Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
Description
The water level in the water separator has risen to the warning level. Example: condensation water.
Reaction in EEM
The FC is stored and the warning lamp is activated. Engine power is reduced (Degradation Level 2).The CAN message indicates an active fault.
Related Content:
WinEEM4s JCB Service Tool 2.7.2 2.6.1 Free Download
2017 JCB Parts Plus+ and Repair Service Manual Free Download
2022 JCB ServiceMaster 4 Free Download for Win 7/Win 8/Win 10
Solution
Examine the water separator at the bottom of the pre-filter. Drain the water from the fueling system.
If there is no water in the fueling system:
Remove the sensor from the fuel filter and clean the sensor element.
Examine the sensor operation with water cup by sinking the sensor element to the water for 1 minute. If fault code appears sensor is functional.
Make sure the wiring from the ECU to the sensor connector is correct.
Make sure the supply voltage is right at the water detector sensor connector from pin A (+12V) to pin C (GND).
If the power supply to the sensor is correct, and there are no breaks or short circuits in the wirings -> replace the sensor.
More repair case for JCB,please refer to:JCB Trouble Repair
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Some Friends don't know how to activate win7, when they receive the diagnostic software with win7 sytem. http://www.chinaobd2.com/upload/software/win7activation.zip download this Read more
Please ensure that you choose computer systems that meet our requirements for the installation. You will find adetailed listing in Read more
Frequent oil changes are perhaps the most important procedure you can do to maintain and prolong the life of your Read more
This article show a guide on how to use G-scan2
Please keep this link if you copy the post!