JCB StageV Engine SPN 109, FMI 3, Coolant Pressure Sensor Voltage Open Circuit

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

JCB StageV engine Coolant pressure sensor voltage above normal or open circuit.The measured coolant pressure sensor voltage signal is above the normal operating range..

Related Contents:

WinEEM4s JCB Service Tool 2.7.2 2.6.1 Free Download

2017 JCB Parts Plus+ and Repair Service Manual Free Download

2023 JCB ServiceMaster 4 Free Download for Win 7/Win 8/Win 10

 

Possible causes are:

The coolant pressure sensor wiring is defective. (Shorted to high source or an open circuit.)

The coolant pressure sensor is defective.

 

Reaction in EEM

The FC is stored and the warning lamp is activated. The CAN message indicates active fault.

 

Solution

First save the error log and then erase it. Restart the ECU after erasing the error log. If the fault occurs again during the next driving cycle, check the following paths:

Check the coolant pressure sensor wiring, the connectors and the contact surfaces of the connector pins (possible oxidation).

Check the operation with another coolant pressure sensor to see if the coolant pressure sensor is defective.

More repair case for JCB,please refer to:JCB Trouble Repair

This Post: JCB StageV Engine SPN 109, FMI 3, Coolant Pressure Sensor Voltage Open Circuit From ChinaOBD2 Official Blog
Please keep this link if you copy the post!