In this instruction, chinaobd2.com show you guide on how to test pilot pressure for JCB 3CX, 4CX, 214e, 214, 215,217 & VARIANTS Backhoe Loader.
Related Content:
WinEEM4s JCB Service Tool 2.7.2 2.6.1 Free Download
2017 JCB Parts Plus+ and Repair Service Manual Free Download
2022 JCB ServiceMaster 4 Free Download for Win 7/Win 8/Win 10
Procedures:
Testing the Pilot Pressure
1 Position the backhoe to enable access to the pilot supply valve.
Before proceeding further the pilot circuit accumulator pressure must be vented.
2 Stop the engine. With the operator seat set in the rear facing position (for backhoe operation), switch the starter to ON without starting the engine. Operate the joystick controls several times to vent the servo pressure from the accumulator. Switch the starter switch to the OFF position.
3 Connect a 0
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Tags: JCB
Related Posts
TOP 18 BEST DIAGNOSTIC TOOLS FOR TRUCKS IN 2024
2024.01.24
How to Use JCB ServiceMaster 4 Diagnostic Tool
2024.01.28
JCB 3CX 4CX Loader Servo Pressure Supply Valve Dismantling and Assembly
2023.05.5
JCB Equipments K0125 Boost Pressure Deviation is too High Repair Guide
2023.04.3
how to Adjust Shovel Reset System for JCB
2024.01.28
JCB Electronic Service Tool SM4.1.45.3 Multi Language Diagnostic Interface
2018.12.17
JCB 3CX/4CX/5CX Foot Throttle Position Sensor Remove/Install and Test Guide
2024.03.12
JCB StageV Tier4 Air Filter Pressure Sensor Active at Init State
2023.10.4
JCB Stage V Engine K4732 Intake Air Temperature Sensor Out of Range
2023.04.6
JCB 214e, 214, 215,217 Backhoe Loader Pilot Hose Removal Replacement Guide
2023.04.3