When replacing the injector,it is necessary to register the ID code printed on the upper part of the injector with handheld tester in the engine ECU.So here i will show you guide on how to use IDSS software to do fuel injector flow rate programming after replacement.
Note:If the ID code of the newly installed injector is not properly registered,rough idling,abnormal noise,or other symptoms may occur.
Preparations:
Isuzu G-IDSS Export 2019 Diagnostic Software Free Download
Procedures:
Connect Nexiq interface to ISUZU diagnostic port,then run IDSS software.
After vehicle identification,select
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!