ISUZU 4LE2 Tier-4 Engine Fuel Temperature Sensor Removal Guide

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

Here is an illustration show you steps on how to remove and install fule filter for ISUZU 4LE2 Tier-4 engine.

 

Related Contents:

ISUZU E-IDSS 2022 2019 Engine Diagnostic Service System Free Download

ISUZU IDSS Diagnostic Tool

 

Procedures:

1 Fuel Temperature Sensor Safety Information

Caution: Add a cleaning agent to the steam cleaner and thoroughly clean the sensor and the supply pump areas.

Caution: Completely remove moisture with an air blower

Caution: Start work after checking that all foreign material has been removed.

Caution: After starting the engine, verify that there is no fuel leakage.

Caution: After replacing, verify that the trouble code is cleared and that the operations are normal with a scan tool.

 

2 Battery Ground Cable Disconnect

1 Disconnect the battery ground cable from the battery.

 

3 Cooling Fan Removal

1 Remove the cooling fan from the fan pulley.

 

4 Cooling Fan Belt Removal

1 Remove the cooling fan belt from the pulley.

Note: Loosen the generator adjust bolt and remove the belt.

 

5 Fan Pulley Removal

1 Remove the fan pulley from the water pump assembly.

 

6 Generator Removal

1 Disconnect the harness connector from the generator.

2 Remove the generator from the generator bracket.

3 Remove the adjust plate from the water pump assembly.

Note: The diagram shows the 24 V

This Post: ISUZU 4LE2 Tier-4 Engine Fuel Temperature Sensor Removal Guide From ChinaOBD2 Official Blog
Please keep this link if you copy the post!