What is InPower?
InPower is a special diagnostic software for Cummings generators.You are able to use it to communicate with Cummings generators electronic controls units (ECU/ECM).
InPower Functions:
Direct connection capability from a personal computer to PowerCommand geneset controls,transfer controls,and system controls;For details on devices supported refer Technical Details tab.
Plot critical parameters in a strip chart format, and export data to 3rd party software tools for manipulation and viewing.
Configurable for units of measurement, and level of user access (read only, read/change values,administrator).
Generates reports of monitored data
Connection to generator set or transfer switch controls via modem or to multiple controls via PowerCommand (LonWorks)network.
Allows released firmware upgrades on Power Command genset controls.
Allows the monitored equipment to send alarm information to a connected computer.
Simulate fault conditions in genset controls in compliance to NFPA 110 requirements to demonstrate functionality of the controller and monitoring equipment in a facility.
Adjustment of nearly every adjustment parameter within the connected control system, including parameters such as voltage and frequency levels, gains, protection set-points and other values.
Viewing of equipment history, fault codes, and data associated with fault codes.
Convenient programming of configurable inputs in the controllers.
InPower Support Systems:
Windows 7,Windows 8,Windows 10 and Windows 11
InPower Software and hardware requirements:
InPower is suitable for use with Microsoft Windows 2000,
Windows XP Pro and Windows NT v6.0. InPower v6.0 does not support Windows 95 or Windows 98 operating systems. See below for further requirements.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!