INPA K+DCAN cable vs ENET cable vs BMW ICOM A2 (icom next)

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

Any cost-effective DIY solution of BMW diagnostic/coding/programming?

First you should know which BMW TOOLS you need: K+DCAN or ENET or ICOM A2/ ICOM Next.

In summary,

It depends on your purpose (diagnostic or coding or programming) and model (Exx or Fxx or others).

For Coding, you need different Tools, NCS Expert / SP-Daten for E-Series and E-Sys / PSdZData for F-Series.

All Diagnosis and Coding can be done with cheap DCAN Cable for E-Series and cheap ENET Cable for F-Series.

For Programming (Flashing ECU’s with new Firmware), then you need ISTA/P for for both E-Series and F-Series cars, or you can use WinKFP for E-Series and E-Sys for F-Series. For E-Series Programming, you will need an ICOM, but for F-Series Programming, you can use ENET Cable.

For Exx- Series:

Interface = K+DCAN Cable (OBDII to USB) or ICOM

ECU Data Files = SP-Daten

NCS Expert = Coding Software

WinKFP = Programming (Flashing) Software

EDIABAS = Low-Level ECU Communication Software used by NCS Expert & WinKFP

For Fxx- / Ixx- / Gxx-Series, Mini, & Rolls-Royce：

Interface = ENET Cable (OBDII to RJ45 Ethernet) or ICOM

ECU Data Files = PSdZData

E-Sys = Coding Software

E-Sys = Programming (Flashing) Software

About: BMW ICOM

ICOM A (also ICOM A2, ICOM A3, ICOM Next A): main interface

ICOM B: adapter for programming multimedia in E series

ICOM C: adapter for old BMW with round 20 pin diagnostic plug

ICOM D: adapter for motorcycles

ISTA+ (AKA Rheingold or ISTA-D)

DIAGNOSTICS for All Vehicles

PROGRAMMING for F/I/G/RR & MINI, but requires an ICOM

ISTA-P

PROGRAMMING traditionally for all chassis, but is being phased out by August 2017, except for legacy E-series.

Replacement ECU’s must be NE

This Post: INPA K+DCAN cable vs ENET cable vs BMW ICOM A2 (icom next) From ChinaOBD2 Official Blog
Please keep this link if you copy the post!