How to use CG100 Prog III and Multi-meter to wire Toyota airbag for reading and writing?
Check the step-by-step guide below.
All goods required:
Airbag: i.e Toyota 89170-06A30, chip R7F701A223
CG100 III Airbag Reset Tool
Multimeter
Tin (Tin the solder joint to make it easier to wiring)
Soldering tool
Wiring steps:
Step1: Find the chip pin diagram in CG100
Step 2: Put some tin on the cables, it will be more convenient for using next time
Step 3: Test if the multi-meter works well or not. The multimeter should be in buzzer mode and can work well
Step 4: Sometimes the chip pin can not detect well, so make some tin on it (if your welding skill not good, don
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!