Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
Xhorse VVDI MLB Tool V2.0.0.0 added MQB48 NEC35XX IMMO data collection function. MQB48 adapter is required to work together. Follow the steps below to update your MLB Tool firmware and enable the MQB48 adapter functionality.
VVDI MLB Tool V2.0.0.0 Update (2025.01.07)
New Features:
Added MQB48 NEC35XX immo data collection function
Functionality:
Similar to MLB, it allows key opening, data reading, and additional key programming.
Supports MQB48 Megamos AES
Reads immo data (CS code) from a working MQB key on the MQB48 platform, enabling key addition without needing to remove the cluster for bench reading
Wiring & Connection Guide
VVDI MLB Tool MQB48 Wiring Diagram
Remove one capacitor (near the IC position) on the original key, as shown in the diagram.
Solder the socket cables to the original key according to the specified colors in the wiring diagram.
Connecting the MQB48 Adapter to the VVDI MLB Tool
Requires additional Xhorse MQB48 adapters (coming soon)
Connection is shown in the diagram.
Upgrading VVDI MLB Tool for MQB48 Adapter Compatibility
The MQB48 adapter includes soldered wires and an enhanced replacement chip.
Disassembly & Chip Replacement:
Remove 4 screws on the back of the VVDI MLB Tool to open the shell.
Remove 2 screws on the mainboard and check the opposite side.
Identify the front side of the main board.
Replace the chip using the enhanced replacement chip included in the package.
Reinstall the VVDI MLB Tool after replacing the chip.
Using the MQB48 Adapter for Immo Data Collection
Ensure both the Xhorse MLB Tool and the MQB48 adapter are connected to a power supply before use.
Once connected properly, you can begin collecting immobilizer data.
Note: The Xhorse MQB48 adapter will be available soon. Stay tuned for updates!
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!