Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
This instruction show you guide on how to use WinEEM4 service tool software to do DPF regeneration.
Preparations:
WinEEM4s JCB Service Tool 2.7.2 2.6.1 Free Download
Procedures:
WinEEM4 service tool DPF regeneration provides the means to activate the DPF regeneration functionality. The graph in the middle of the page plots the temperatures which are most relevant to DPF regeneration process. Several other relevant values are displayed in the right side of the page.
When test is activated by user, engine speed will be set automatically to ~1500 rpm. Engine Management System then starts controlled DPF regeneration process. The process takes about 30-50 minutes, time may vary due to environmental conditions and DPF soot load level. During DPF regeneration engine noise level may vary. Process progress will be shown to user. After DPF regeneration engine will return to low idle. Let engine cool down on low idle minimum of 2 minutes before shutdown.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Some Friends don't know how to activate win7, when they receive the diagnostic software with win7 sytem. http://www.chinaobd2.com/upload/software/win7activation.zip download this Read more
Please ensure that you choose computer systems that meet our requirements for the installation. You will find adetailed listing in Read more
Frequent oil changes are perhaps the most important procedure you can do to maintain and prolong the life of your Read more
This article show a guide on how to use G-scan2
Please keep this link if you copy the post!