How to Use SerDia2010 to Set Speed Droop for Deutz Engine

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

This instruction show you guide on how to use SerDia2010 diagnostic software to set speed droop for Deutz engine. It is provided for using this function, that the engine is operating in min-/max-governor or allspeed-governor mode (f.e. not fixspeed).

 

Preparations:

Deutz Diagnostic Kit DECOM for Deutz Engine

2023 Deutz Serdia2010 v14.1.9.1 Diagnostic Software Free Download

Deutz Serpic EPC Parts Catalogue 2014 2012 Free Download

SerDia2010 reads out the actual characteristic lines for Droop and copies both values into the upper chart. Additional the values will be saved.
In parallel the tachometer operates on the right hand.
The actual setpoint value and the actual rotating speed are shown, each as a decimal value below the tachometer and also with indicator and hysteresis region.

Possible interactions:

Button “read data from ECU”:

went back to previous value of droop, which was acquired at the start of the UseCase.

Button”store in ECU”:

writes all variables for the droop back into the ECU.
If the engine is still running, SerDia will offer to stop the engine automatically,so that the programming of the ECU can take place.

text box “Speed Droop 1 set” or “Speed Droop 2 set”:

An input into this text box has to be confirmed by ENTER.
After that, SerDia changes all variables for droop and switches over to working page, so all changes will be activated in realtime.

The input is limited from 0 to 20 % .

For more repair case of Deutz engine,please refer to:Deutz Engine Repair

This Post: How to Use SerDia2010 to Set Speed Droop for Deutz Engine From ChinaOBD2 Official Blog
Please keep this link if you copy the post!