How to Use Cat ET 2025A Power Shift Pressure Test Function?

Posted on by
CAT ET 2025A

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

CAT ET 2025A Power Shift Pressure Test function checks whether that the proportional reducing valve is activating with a current signal from the controller.

This function also allows the power shift pressure signal to remain constant at a desired pressure level. The constant power shift pressure signal is necessary to allow testing and adjusting procedures to be performed to line relief valves.

CAT ET 2025A

Related Contents:

Caterpillar ET 2025A 2018A Electronic Technician Software Free Download

CAT Communication Adapter 3 478-0235

Caterpillar Factory 18 Digits Password Service

Accessing

To access the diagnostic test, select “Diagnostics” from the Service menu, and then select the desired test from the submenu.

Note: The Diagnostic Test Status box is displayed after each component has been tested or when the Cancel button has been selected in the diagnostic test screen. The status results are displayed as “Success,” “Pending,” “Failed,” or “Cancelled”.

Screen Layout

The diagnostic test screen consists of the following areas:

Status Parameter Area

The status parameter area lists parameters needed for the test and their current values.

Status Line

The status line is located in the center of the screen. It displays messages regarding the test process. It provides instructions and status information while the test is being performed.

Instruction Area

The instruction area occupies the center of the screen. It displays the sequence of events for the completion of the test, as well as the service tool’s progress through the necessary steps. The step to be performed is bolded; all other steps are gray.

Buttons

Depending upon the calibration, the buttons available are:

Start – Click this button to begin the test. The pressure and/or engine speed can then be manipulated manually with the arrow buttons underneath the slider bars. After this button is clicked, it is disabled until the test is stopped

Begin Sweep – Click this button to sweep pressure through the range automatically. The sweeping continues back and forth until the End Sweep button is clicked

End Sweep – Click this button to stop the sweeping of pressure and/or the engine speed.

Cancel – Click this button to end the diagnostic test at any time. If the button is clicked before End Sweep is clicked, the test is aborted and the status line will read “Service Test Unsuccessful.” This button is disabled until the test is started.

The pressure control area allows an increase or decrease in pressure. The pressure range is indicated by a horizontal slide bar, with the parameter reference numbers displayed to the left and right of the bar. The current value is displayed above the slide bar. A vertical slide indicates the current value. The buttons used in this area may include:

– Click to decrease a variable value rapidly

– Click to decrease a variable by one value

– Click to increase a variable by one value

– Click to increase a variable rapidly

Note: For some products, volume replaces pressure as the parameter’s measurement.

More repair case for Caterpillar machine,please refer to:Caterpillar Machine Repair

How useful was this post?

Click on a star to rate it!

Average rating / 5. Vote count:

This Post: How to Use Cat ET 2025A Power Shift Pressure Test Function? From ChinaOBD2 Official Blog
Please keep this link if you copy the post!

Tags:

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *