Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
Recently,some readers of chinaobd2.com feedback that their BMW ICOM or BMW ICOM NEXT can not work correctly on BMW ISTA+ new version software.This error caused by ICOM or ICOM Next firmware old.So to solve this problem,you need to update the firmware.This instruction show the step by step guide for BMW ICOM and BMW ICOM NEXT diagnostic tool firmware update.
Notice:Try it at your own risk!!!
Related Contents:
2024.05 BMW Rheingold ISTA+ 4.47.18 4.23.14 ISTA-P 3.71 Free Download
Procedures:
Step 1:
Connect BMW ICOM/ICOM NEXT to PC by internet cable/LAN cable
Run ISTA software,then click
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Tags: BMW ICOM NEXT cat ICOM NEXT
Related Posts
Yanhua Mini ACDP program key on Land Rover KVM (MC9S12XEQ384 112Pin)
2019.04.9
How to Disable BMW X5 2013 N55 Oxygen Sensor Trouble Codes 2D22 2D13
2023.04.4
How to Program 2018 BMW 530LI xDrive G38 EPS by Launch X-431 Pad 7
2024.01.28
John Deere Service Advisor Coverage
2024.01.28
Jpro Toolbar Perform a Comprehensive Electronic Inspection With Visual PM Inspec...
2024.01.28
Xhorse Remote Tester V2 Operation Guide
2023.03.15
How to make Xentry PassThru work for New Models (Euro5/6, W205, W213, W222)
2019.03.11
FCOM Ford OBD2 Diagnostic Software Introduction
2019.05.14
How to Remove Temperature Sensor for MTU 12-16v Engine
2024.08.10
How to Setup Zed-NET for Zed-Full for Internet Work
2019.07.24