Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
Here is the instruction show you guide on how to solve Scania truck alarm system ALM259 Secondary wake-up signal,short circuit.
Related Contents:
2024.07 Scania SDP3 V2.61.2 V2.40 Diagnostic Software Free Download
Scania VCI3 Diagnostic Adapter Full Chips
2024 2018 Scania Multi EPC Parts Catalogue Free Download
Secondary wake-up signal, short circuit
Error identification
The secondary wake-up signal is short-circuited to ground.
Cause
Faulty cable harness for the secondary wake-up signal.
Faulty ALM control unit E7.
Notes
–
Symptom
The control unit cannot wake up or be woken up by units connected in the CAN network.
Action
Disconnect the harness-to-component connector to ALM control unit pin A3.
Measure for short circuits throughout the cable harness.
If there are several harness-to-component connectors between the wake-up signal and the control unit, disconnect them and measure to locate the fault.
If the fault is not in the cable harness it is probably an internal fault in the ALM control unit.
For more information about Scania truck,please refer to:Scania Trouble Repair.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Some Friends don't know how to activate win7, when they receive the diagnostic software with win7 sytem. http://www.chinaobd2.com/upload/software/win7activation.zip download this Read more
Please ensure that you choose computer systems that meet our requirements for the installation. You will find adetailed listing in Read more
Frequent oil changes are perhaps the most important procedure you can do to maintain and prolong the life of your Read more
This article show a guide on how to use G-scan2
Please keep this link if you copy the post!