Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
Xentry program starts does not see C4/C5 interface. Tried on other backup computer it works. But gets message attached
“Fault XENTRY Update Service
XENTRY Update Service interrupted. Restart the system or contact your administrator.”
How to solve this issues ?
The reason may be: You didn’t set IP address as following picture, so it can’t work
OBDII.SHOP Attention : for software activation , you can’t do it yourself , or will be damaged the software.
Related posts:
How to reset the fuel mixture adaptations for Mercedes ME9.7
How to Update MB SD Connect C4 Firmware
How to Fix Error 749 for MB Star SD Connect C4 ?
How to Setting SD C4 PLUS DOIP IP Address ?
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!