How to Solve Autocom Delphi Firmware Update Fail Error

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

This is a tutorial to fix Autocom/Delphi Firmware update Fail Error when autocom/delphi firmware can not be upgraded using Autocom/Delphi software application.

Step 1: you need to open the case of Autocom / Delphi hardware. and remove main board from case.

Step 2: Find MCU STM32 Big Grin on PCB, to enter MCU into Boot mode you need to connect legs 108 nad 138 together with some wire.
Notice: you can do that as on attached pictures (test point TP205 or TP206 connect with capacitor) but some of units have different PCB so you need to solder directly to the legs or find test points with multimeter.

Step 3: install and run

This Post: How to Solve Autocom Delphi Firmware Update Fail Error From ChinaOBD2 Official Blog
Please keep this link if you copy the post!

Tags: cat

Related Posts

How to Use XPROG-M to Read Freescale MC68HC908GR16(0M76Z)

2019.03.21

Autocom CDP Pro

2019.02.24

Yanhua ACDP2 Correct Mileage for Toyota R7F714xx ODO/Buick BCM (NEC3558)

2024.12.24

What Scania VCI3 Interface Light Lamps Indicate?

2023.04.3

Detroit GHG14 Engine Idle Does not Go into Continuous Run Mode

2024.01.24

How to Use Ford IDS with FVDI J2534 Diagnose for Ford Focus 1.6L

2019.06.17

Scania SDP3 2.52.1 Diagnosis & Programming Software Installation Service

2022.06.15

Nissan Consult 3 Plus Reprogramming ECU TCM Guide

2019.03.27

LCD Instrument Cluster Retrofit Coding by JLR PATHFINDER for Range Rover L494

2023.04.4

What is the Difference Between Ford IDS and FCOM

2019.05.31