Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
This instruction show you guide on how to solve Allison 3000 & 4000 Gen5 engine fault code P0703 break switch circuit.
Related Contents:
2023 Diesel DTC Solutions V2.9.98+ Diesel Explorer 2.0+Instruction
2024 2019 Allison DOC Transmission Diagnostic Software Free Download
DIAGNOSTIC RESPONSE:
No Neutral to Drive shifts for refuse packer. TCM inhibits retarder operation if a TPS code is also active.
CIRCUIT DESCRIPTION:
This test monitors whether vehicle service brake switch status is in a stuck “ON” or “OFF” state.
ACTION TAKEN WHEN THE DTC SETS:
1 The TCM does not illuminate the CHECK TRANS light.
2 DTC is stored in TCM history.
3 Some feature ranges may be inhibited when a valid Service Brake Status(SBS) state is not detected by the TCM. The range inhibit light will illuminate when range is inhibited.
CONDITIONS FOR CLEARING THE DTC/CHECK TRANS LIGHT:
Use the diagnostic tool to clear the DTC from the TCM history. The TCM automatically clears the DTC from the TCM history if the vehicle completes 40 warm-up cycles without the DTC recurring.
DIAGNOSTIC AIDS:
1 Open or short in wire 103 or wire 162.
2 Malfunctioning brake system control components such as:
– Miswired or defective brake system wiring.
This DTC may be caused by:
– Defective brake pressure switches.
3 Defective TCM.
More Allison repair case,please refer to Allison Trouble Repair
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!