Vehicle model:
VW Polo 2015 (or other Audi, Seat, Skoda, VW with unit 1S1 909 144 P)
Module:
Control unit for steering column electronics VAG 1S1 909 144 P (1S1909144P) eeprom 93C86.
Problem:
After an accident, the EUR did not work, airbag was cleaned, the error P1609 is not erased in the EUR. Any know how i can solve this fault? is possible reset memory?
How to reset steering column module?
You can reset the module using VCD-S or ODIS.
If use the ODIS is possible to clear crash information by OBD. But ODIS stays online. Some said it can be done offline, but don’t the procedure.
Here’s the guide to reset EUR by using OBDSTAR X300 DP/Key Master DP (You need EEPROM Adapter to read dump).
Remove and disassemble the module, find out EEPROM chip 93C86
Read dump and reset
EUR indicator went off.
Done.
www.chinaobd2.com
This post is from China OBD2, Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!