Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
This post focus on how to use JLR SDD to reset service interval for Land Rover L359 2010 by JLR SDD.
Preparations:
How to Install JLR SDD Diagnostic Software
Newest JLR SDD V154 Software Free Download
Procedures:
Connect the JLR SDD hardware device to vehicle,and run the JLR SDD on your laptop.
Click SDD
Click[Auto VIN Read]
Reading VIN…
Click [Diagnosis]
Symptom Selection and click [Continue]
Click [Recommendations]
Click [Run] Special applications: Service interval reset
Click [Agree]
Set the ignition switch to on. Press tick to continue
Press tick to continue
Ensure an approved battery charger is connected.
Set the ignition switch to off. Press tick to continue
Processing car configuration file data is completed.
Make sure the ignition is switched on. Press tick to continue
Service interval:Read the vehicles time and distance related is completed
Global real time:Read the vehicles time and distance related is completed
Set the ignition switch to off. Press tick to continue
Make sure the ignition is switched on. Press tick to continue
Resetting the service interval is completed
Set the ignition to off. Press tick to continue
Set the ignition to on. Press tick to continue
Clear the fault codes? Press tick to continue
Clearing the fault codes.
Clear the fault codes is completed. Press tick to continue
Set the ignition switch to off. Press tick to continue
Initialising… Press tick to continue
Set the ignition switch to on. Press tick to continue
Control module procedure completed successfully. Press tick to continue
Set the ignition switch to off. Press tick to complete
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!