How to Replace Mercedes Benz Knock Sensor

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

Knock sensor detect knock or ping in the motor, which is pre detonation and can cause serious and expensive damage to the motor. If knock is detected the sensor will tell the management system of the engine to severely retard the ignition. Besides an error code you will notice a lack of power and throttle response.Here I share the procedures of how to replace Benz knock sensor.

 

The sensors are easy to replace once you get access to them. Unfortunately, you will need to remove the fuel rail, injectors and intake manifold. Please see our articles on how to perform this work. Note: The knock sensors are torque sensitive and over or under torquing them will result in incorrect readings from the sensors and poor performance from the motor. The sensors must be torqued to 20Nm on the 272 engine.

 

Applies to: C350 (2007-14), SLK350 (2004-14), CLS350 (2004-14), CLK350 (2005-14), E350 (2005-14), S350 (2005-14), SL350 (2005-14), R350 (2006-14), ML350 (2006-14), Viano (2005-14), Sprinter (2006-14), CLC350 (2008-14), GLK350 (2008-12)

 

 

Preparations:

Time: 30 minutes

Tab: $35 to $70

Talent: 2 T

ools: E10 socket, torque wrench

Parts Required: New knock sensors sensor, intake manifold gasket

Hot Tip: Don’t work on a hot engine

Performance Gain: Piece of mind on engine knock

Complementary Modification: New injectors

 

Procedures:

You need to remove the engine covers and air intake ducts to perform this work,check here to get the detail information: How to Remove Benz C Class W204 Engine Cover

 

Next you need to remove the intake manifold to get the motor to this stage.Please see our article on intake manifold removal:How to Remove Mercedes Benz Intake Manifold

 

With the manifold removed you can see the two knock sensors in the

This Post: How to Replace Mercedes Benz Knock Sensor From ChinaOBD2 Official Blog
Please keep this link if you copy the post!