This guide provides step-by-step instructions on how to remove the oil pressure regulation valve from a CLAAS AXION 950 or 920 tractor.
Related Contents:
CLAAS CDS 7.5 Diagnostic Software
CLAAS WEBTIC OFFLINE ENGLISH 2024.07 contains repair and service information
Removal Procedure
The oil pressure regulation valve can be removed without disassembling the oil filter support. Follow these steps for a proper removal:
Remove the Bolts
Unscrew and remove the two bolts securing the valve.
Extract the Valve
Manually pull out the oil pressure regulation valve.
Remove the Locking Ring
Detach the locking ring carefully.
Inspect the Spring
Check the spring’s length and overall condition to ensure it meets the technical specifications.
Replace the O-Ring
Install a new O-ring for a secure seal.
Lubricate the O-Ring
Apply lubrication to the O-ring to prevent leaks and ensure proper installation.
Reinstall and Secure
Tighten the bolts securely to complete the process.
By following these steps, you can efficiently remove and inspect the oil pressure regulation valve on your CLAAS AXION 950 or 920 tractor. Always adhere to the manufacturer’s technical specifications for optimal performance and longevity.
Related posts:
Adjusting Tooth Play on the Control Pinion of a CLAAS AXION 920 Tractor
How to Remove and Install Perkins Engine Ignition Coil
How to Remove the Cummins M11 Series Engine Hydraulic Pump, Sensor Wiring Harness, and Internal Actuator Wiring Harness
Detroit GHG17 Heavy-Duty Mechanical Cylinder Compression Test Guide
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!