Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
This instruction show you guide on how to remove injector for Mitsubishi D04EG diesel engine.
Related Contents:
Mitsubishi V.C.I Diagnostic Kit
Mitsubishi EngineScope Diagnostic Software
Procedures:
(1) Remove the harness.
(2) Fix the fuel inlet connector of injector with wrench,loosen the injection pipe nut and remove the injection pipe.
(3) Fully press the pin at the top injector and remove the leak-off hose.
(4) Remove the connector of main harness and the injector connector.
(5) Loosen the nozzle gland bolt, and remove the injector together with the nozzle gland using the injector puller.
(6) Remove the gasket at injector inserting port in cylinder head.
(7) Install the protection cap to the injector immediately after the removal to avoid dust entering.
Note: Wait 30 seconds or more after the engine stop to start the injector removal job.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!