Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
This service bulletin show you guide on how to remove and fit rear oil seal for Perkins 1000 series engine.
Related Contents:
Newest Perkins EST 2022A & 2019A Full Support Free Download
Perkins SPI2 2018A EPC+Service Manual Free Download
Procedures:
1 Release the setscrews which retain the flywheel and remove the flywheel (A3).
2 Release the setscrews (A5) which retain the cover (A4) and remove the cover. Remove the joint (A2) and clean the joint faces of the cover and flywheel housing.
3 Release the setscrews and the cap screws and washers which retain the housing (A11) for the rear oil seals and remove the housing.
4 Clean the joint faces of the seal housing and cylinder block.
5 Clean the crankshaft palm (A8) and check for wear in the seal location areas. If there is wear, a
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Some Friends don't know how to activate win7, when they receive the diagnostic software with win7 sytem. http://www.chinaobd2.com/upload/software/win7activation.zip download this Read more
Please ensure that you choose computer systems that meet our requirements for the installation. You will find adetailed listing in Read more
Frequent oil changes are perhaps the most important procedure you can do to maintain and prolong the life of your Read more
Please keep this link if you copy the post!