Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
This illustration show you guide on how to remove and install stone trap for CLAAS Lexion 480 combine agricultural machine.
Related Contents:
CLAAS CDS 7.5 Diagnostic Software 2021 2020 Free Download
CLAAS USB Interface Diagnostic Adapter Package
Claas WebTIC Offline Repair & Service 2024 2015 Free Download
Notice:
Raise the feed rake conveyor its highest position and put the cutterbar cylinder safety lock into position.
Pull the tensioning lever (S) forward, then swing the stone trap door to the front and arrest the spring hook (F) at lever (H).
Remove the M 12 x 40 hex. bolts (K) from both sides of the stone trap.
Remove the turn lock (G) and remove the stone trap.
Remove the 4.8 x 12 blind rivet from the terminal strip.
Replace the rubber seal and rivet it back to the terminal plate on the trough.
Installing the stone trap
Lift the stone trap into the machine and bolt the bearings on the left- and right-hand side back into position.
Swing stone trap up and screw on the turn lock.
Release the lever, then fold back door and secure with the tensioning lever.
More repair case for CLAAS,please refer to CLAAS Trouble Repair
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!