How to Remove and install PCU for HINO J05E Engine

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

When you need replace new PCU for J05E engine,you need to remove and install new one.Here car-auto-repair.com show you guide on how to remove and install it.

 

Preparations:

Nexiq USB2 Diagnostic Adapter

2023.03 HINO Diagnostic Explorer DX3/DX2 Diagnostic Software Free Download

HINO Trucks EPC Electronic Parts Catalog 2018?2016 Free Download

 

Procedures:

REMOVING THE PCU

1 DISCONNECTING THE AUXILIARY BATTERY.

(1) Disconnect the auxiliary battery negative terminal.

2 REMOVING THE SERVICE PLUG.

3 DISCONNECTING THE MOTOR CABLE AND 24V POWER CABLE.

Unfasten clips (4 pcs.) to remove the under cover service hole cover.

(2) Remove the bolts (4 pcs.) and remove the inverter terminal cover.

(3) Remove bolts (6 pcs.) and detach the motor cable.

4 DISCONNECTING THE CONNECTOR.

(1) Unfasten the clips (2 pcs.) and remove the front panel.

(2) Disconnect the connectors (2 locations).

5 REMOVING THE PCU.

(1) Set the engine lifter on the PCU.

(2) Remove the nuts (6 pcs.) to remove the PCU.

 

Install the PCU

1 MOUNTING THE PCU.

(1) Set the engine lifter on the PCU.

(2) Mount the PCU using the nuts (6 pcs.).

Tightening Torque:

115 N

This Post: How to Remove and install PCU for HINO J05E Engine From ChinaOBD2 Official Blog
Please keep this link if you copy the post!