How to Remove and Install ECM for Hitachi ZX890-7 Excavator

Posted on by VCDS
How-to-Remove-and-Install-ECM-for-Hitachi-ZX890-7-Excavator-2

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

It is necessary to remove ECM when you need do ECM flashing,ECM replacement.So here chinaobd2.com show you guide on how to remove and install ECM for HITACHI ZX890-7 excavator.

 

Related Contents:

Hitachi MPDr v2.56 v2.25 Diagnostic Software Free Download

Hitachi Excavator ZX-7 Service Repair Workshop Manual 2021

Hitachi Dr.ZX Excavator Diagnostic Tool Cable

 

Procedures:

Removal of ECM
1.Set the machine position for inspection and maintenance. (Refer to Preparation before Inspection and Maintenance in the separate Workshop Manual.)

IMPORTANT
2.Set the key switch to the OFF position. Wait 5 minute or longer, and then set battery disconnect switch to the OFF position.
Set the battery disconnect switch to the OFF position.

3.Remove the DCU.(Refer to

How useful was this post?

Click on a star to rate it!

Average rating / 5. Vote count:

This Post: How to Remove and Install ECM for Hitachi ZX890-7 Excavator From ChinaOBD2 Official Blog
Please keep this link if you copy the post!

Tags:

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *