Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
This instruction is show you in detail how to intall the OLM Spec CR Sequential LED taillights for the Subaru 2015+ WRX and STI.The car in the video is a 2020 STI. These lights are available at many different performance parts stores online.
More cases of Subaru, please refer to Subaru.
Steps:
The tail lights which are ready for installation should come well protected in the box and individually wrapped inside.
Clear out a few things to get to the tail light.
After clear out the trunk , remove trim piece. There are three pop clips holding it in place.
Grab your panel and clip removal tool and get them out.
Pulling trim piece straight up.
Use a flathead or panel removal tool to take out retaining clips between the outer and inner parts in order to remove covers on both sides.
Once you get covers out, you
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Some Friends don't know how to activate win7, when they receive the diagnostic software with win7 sytem. http://www.chinaobd2.com/upload/software/win7activation.zip download this Read more
Please ensure that you choose computer systems that meet our requirements for the installation. You will find adetailed listing in Read more
Frequent oil changes are perhaps the most important procedure you can do to maintain and prolong the life of your Read more
This article show a guide on how to use G-scan2
Please keep this link if you copy the post!