There have customers have issues use BMW ICOM Next :
I have bmw next when i plugged OBD to socket, system led started flashing red.
I tried re-flashing Firmware and configure user settings but nothing changed still led flashing red.
The problem is that the problem with the processor and the algorithm for writing errors in the firmware from the old icom.
How to fix it ?
You can remove the error by connecting a three-wire fan or a pulse generator with a frequency of 400 Hz.
For normal operation it is necessary to set cool the CPU
You need to buy a small fan with three wires and solder it. On top of the processor i will put some thermal paste with heatsink also.
Question: You know which of this 4 hole is for: Ground (GND), Live wire (VCC 5V) and Third Wire for fan control ? There are 4 holes and 3 of them have trails that goes to the board.
Connection of a fan or generator to 400Hz
More interesting , welcome to check chinaobd2.com
Thanks
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Related Posts
Yanhua Mini ACDP Adds CAS1-CAS4 Data Renew Function
2019.03.8
Yanhua MB CAN Filter 18 in 1 Benz/BMW Universal Filter
2018.12.17
Newest BMW AK90+ II Key Programmer for All BMW EWS Version V3.19
2018.12.17
2018.3 BMW ICOM Software ISTA-D 4.09.13 ISTA-P 3.63.2.001 Engineering Mode Windo...
2018.12.17
Can Yanhua acdp read 2008 BMW 335 ISN?
2019.12.19
Best Quality Wifi BMW ICOM Next A + B + C New Generation of ICOM A2
2018.12.17
GM Tech 2 TIS2000 Dongle Installation guide
2019.11.3
V-CHECKER V401 for BMW Diagnostic Tool
2018.12.17
How to do BMW engine re-adaptation using ISTA D or ISTA+
2019.12.26
AK90 Key Programmer AK90+ For All BMW EWS From 1995-2005
2018.12.17