Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
In this article, we are going to show you how to do odometer correction for Toyota Corolla GLI 2019 with a cheap Iprog+ Programmer.
Original Odometer:
Remove the dash and start it.
Then we are going to use probe adapters.
Run Iprog software,
Go to
Select chip/info>>denso2>>Toyota_Corolla_93C66_2015
Check the pinout.
Connect circuit board to Iprog Plus.
Connect pins.
Connect the probe adapter.
Read the odometer.
Save file.
Correct and write odometer.
Disconnect all and install dash back.
Odometer correction success.
CRE: Malik Locksmith
If you want to know more about Odometer Correction Tools, Please visit https://www.chinaobd2.com
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Handy Baby 2 II Key Programmer Hand-held Car Key Copy Key Programmer for 4D/46/48 ChipsNote: Language: English, SpanishThis Device can't work together Read more
Renault CAN Clip V175 and Consult 3 III For Nissan Professional Diagnostic Tool 2 in 1 Descriptions of Consult 3 Read more
Super VAG K+CAN V4.6 Top 3 Reasons To Get Super VAG: Software Version: V4.6Supported Languages: English/ Spanish/ Italian/ Portuguese/ GreekUDS Protocol Read more
CHIP PROGRAMMER SOCKET SSOP34 This is the SSOP34 socket adapter for chip programmer. Package including: 1pc x CHIP PROGRAMMER SOCKET Read more
Please keep this link if you copy the post!