Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
Here is an instruction show you guide on how to use CGDI CG100X programmer to do odometer modification for BYD HAN.
Original mileage value is 197300KM
Procedures:
Remove the dashboard instrument PCB board
Then locate the CPU chip R7F701621 and 8 pins chip 24C16
Remove 8 pins chips or use the clips to build connect to CG100X programmer
Run CG100X software,select
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Related Posts

DSPIII+ DSP3+ Odometer Correction Tool Full Package Software Updated in 2023
2024.01.28

Lonsdor K518ISE programs 2005 Ford Focus key in two minutes
2019.03.21

GLK 250 cdiX204 AKL Solution with CGMB
2023.04.13

Autel Maxisys ELITE II vs. MS909 vs. MS919
2024.01.24

How to Read and Write VW IAW 9GV ECM with OBDSTAR DC706 on Bench
2024.01.28

How to Remove and Disassemble Instrument Cluster for BMW Z3
2019.05.31

Cheap BMW OBD2 reader reviews: Autel AP200, INPA, ISTA / P, Foxwell NT530, C110
2019.12.24

Cat Caterpillar ET Cat ET 2024A Cleared the Error
2024.12.8

2019 Lonsdor K518S VS 2017 K518ISE: wins in 3 packages
2019.03.8

How to Use Launch Thinkdiag ?
2024.01.28