Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

The Communications tab in the Settings dialog box can be used to set the communication interface device and ports required to run the service tool. NOTE: The information on the Communications tab depends on the selected communication interface device.
#To set the communication settings:
1). Open the Caterpillar ET Software. It will automatically connect to the ECM.
2). Click Stop Connect.
3). Select Utilities
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Related Posts

Mercede Benz MB diagnostic tool reviews and comparison
2020.01.3

(Solved) FORScan Win10 Error:
2019.02.27

How to perform hydraulic pump pressure test for New Holland T6030 tractor
2024.01.28

Zed-Full All Keys Lost Programming for Ford Transit 2017+ by OBD
2019.07.24

Diamond Logic
2019.07.24

Volvo PTT Calibrate Electrical Unit Pump for Volvo MACK I II III
2019.06.17

FCOM Ford OBD2 Diagnostic Software Introduction
2019.05.14

DIY:How to Remove ECU for Toyota FT86
2019.05.31

Can
2024.01.28

Newest BMW AK90+ II Key Programmer for All BMW EWS Version V3.19
2018.12.17