Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
This article is a Volvo PTT Premium Tech Tool software adapter configuration instruction.Hope it helps!
Volvo PTT Related Contents:
Volvo PTT Premium Tech Tool PTT 2.6.0.29 All Version Free Download
How to Install Volvo Premium Tech Tool PTT Software
1.Tech Tool settings
In Settings you are able to configure the Communication Unit.
- Communication unit
To start setting up your communication unit access Settings on the Tech Tool menu or through the shortcut in the toolbar under the Product tab.
Premium Tech Tool
Tech Tool Menu Tech Tool Toolbar
2.Communication Unit settings
In this tab you can select which Communication Unit should be active. It is possible to have several communication units configured on the same computer.
Communication Unit settings [CONT.]
By default Vocom/88890020/88840133 is always installed and ready to be used in USB mode.
In the list you will also see any RP1210 A/B/C compliant driver that you have installed on your machine.
Please Note: Although Tech Tool will list any RP1210 compliant driver, only the following communication units are officially supported by Tech Tool:
- Nexiq USB Link (USB and Bluetooth)
- Nexiq USB Link 2
- Noregon JPRO DLA+
- Noregon JPRO DLA+PLC
- Noregon JPRO DLA+Wireless (USB and WLAN)
- Dearborn DPA 5 (only USB, Dual or Quad device)
- Dearborn DPA 4 Plus
Note: DPA 4 Plus does not support newer vehicles (OBD2013 and OBD2014)
- XscapeEz EZ Tap
Note: EZ Tap does not support newer vehicles (OBD2013 and OBD2014)
3.Activate
This option will activate the selected communication unit to be used by Tech Tool. This means that Tech Tool will look for the activated communication unit only.
Select to highlight the communication unit (adapter) to setup. Click the “Activate” button. The “Status” column for the selected adapter will display “Active” with a green check indicating your adapter is setup.
Note: If you connect a communication unit other than the currently activated one, Tech Tool will not recognize it until you activate it.
Click “OK” to save and exit the Settings window.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Tags: adapter cat OBD2 PTT Software Vocom
Related Posts
FUSO Truck Engine ECU Reprogramming by Xentry
2023.05.10
Automotive CAN Bus System Explained Instruction & Diagnosis
2019.02.27
How to Open the Corresponding Disk When Running Mitchell Ondemand5 Software
2019.07.24
Volvo PTT Do Cruise Control Parameter Programming for Mack I II III
2019.03.2
Jeep Cherokee Powertrain Control Module PCM Initialization Guide
2019.05.14
How to Install & Setup Original wiTECH Diagnostic Extender
2019.07.24
How to Remove & Install EMS Module for Scania C/K Series Truck
2023.04.3
Bobcat 3450 Utility Vehicle Hydraulic Power Unit Removal & Installation
2023.12.8
How To Do GM Control Module Programming With Multiple Diagnostic Interface (MDI/...
2019.12.16
Ford ABS Module Program After Replacement by Launch X431
2019.05.14