How to Clone Hyundai BOSCH TC60.X.X TCM by OBDSTAR DC706

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

OBDSTAR DC706 ECU Tool with OBDSSTAR P003 Adapeter ( TCM V30.09) can perform EEPROM/flash read and write operation on Hyundai ZF 6HP19 & 6HP26, BOSCH TC60.X.X & TC80.X.X, and KEFICO CPGDSH2.2X.X TCM on bench. It’s the same as Kia except 6HP19 and TC80.X.X.

Brand	ECU Brand	Type	Read & write EEPROM	Read & write flash	Connection Method
HYUNDAI	ZF	6HP19			BENCH+P003
HYUNDAI	ZF	6HP26			BENCH+P003
HYUNDAI	BOSCH	TC60.X.X			BENCH
HYUNDAI	BOSCH	TC80.X.X			BENCH
HYUNDAI	KEFICO	CPGDSH2.2X.X			BENCH
KIA	ZF	6HP26			BENCH+P003
KIA	BOSCH	TC60.X.X			BENCH
KIA	KEFICO	CPGDSH2.2X.X			BENCH

Here takes TC60.X.X TCM as an example to show how to clone with DC706.

First, prepare all goods below.

OBDSTAR DC706 tablet
Main cable
OBDSTAR P004 Adapter+Jumper Cable
HYUNDAI BOSCH TC60.X.X TCM

Next, connect a power supply to DC706, and keep charging and communication during the operation.

Then, select ECU Flasher>> TCM>> TCM V30.09>> HYUNDAI BOSCH TC60.X.X TCM (BENCH), and complete the harness connection according to the Pinout.

A-Pin 2: 12 V (16)

A-Pin 3: 12V (16)

A-Pin 6: GND (4+5)

A-Pin 65: CAN L (14)

A-Pin 87: CAN H (6)

Connect P004 ECU Clone Jumper to TCM and P004 Adapter, then connect adapter to DC706 with the main cable.

After the harness is completed, click “Start” to enter the operation interface.

Connect to ECU (switch ignition off and turn on)

Read the original MAPS, INT EEPROM and INT Flash in sequence

Select the corresponding original data to write into a new TCM, all are successful.

Finally, switch the ignition off

Done!

Learn more: https://www.chinaobd2.com/vp-obdstar-dc706-ecu-tool-full-version-plus-p003-kit.html

This Post: How to Clone Hyundai BOSCH TC60.X.X TCM by OBDSTAR DC706 From ChinaOBD2 Official Blog
Please keep this link if you copy the post!