This instruction show you guide on how to change oil level for JCB 3CX,4CX,214e,214,215,217 & VARIANTS backhoe loader.
Related Contents:
How to Install JCB ServiceMaster 4 v21.2.4 2021 on Win7/Win10
2021 JCB ServiceMaster 4 Free Download for Win XP,Win 7,Win 8,Win 10
Procedures:
1.Make sure the park brake is engaged and the transmission set to neutral. Lower the loader arms and backhoe to the ground, switch OFF the engine and remove the starter key.
2.Open the bonnet, see Engine Panels, Opening and Closing the Bonnet.
3.Check that the oil level is between the two marks on the dipstick A.
4.If necessary, remove the side panel and add oil through filler B. Make sure that the dipstick and filler cap are fully inserted and tightened.
Changing the Oil and Filter
1.Drain the oil when the engine is warm as contaminants held in suspension will then be drained with the oil.
Park the machine on firm ground.
WARNING
Make the machine safe before getting beneath it. Lower the attachments to the ground; engage the parking brake; remove the starter key, disconnect the battery.
2.Make sure the park brake is engaged and the transmission set to neutral. Lower the loader arms and backhoe to the ground, switch OFF the engine and remove the starter key.
3.Open the bonnet, see Engine Panels, Opening and Closing the Bonnet.
4.Drain the oil:
! CAUTION
Oil will gush from the hole when the drain plug is removed. Hot oil and engine components can burn you.
Keep to one side when you remove the plug.
Place a container of suitable size beneath the drain plug.
Remove drain plug C and its
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!