How to Calibrate Throttle Position Sensor for Bobcat 5600 Series ToolCat

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

The throttle position sensor calibration procedure in this section shows how to calibrate the throttle position sensor on machines that are equipped with power management option by following the service analyzer instructions displayed on the Service PC.

 

The drive system calibration procedure shows how to calibrate the drive system by following the service analyzer instructions displayed on the Service PC.The travel pedal and brake calibration procedures show how to calibrate the travel and brake pedals output ranges by following the service analyzer instructions displayed on the Service PC.

 

Throttle Position Sensor Calibration

Place the machine on jackstands.

Connect the remote start tool to the machine.

Connect the Service PC to the remote start tool,run Bobcat Service Analyzer software.

NOTE: The utility work machine must be equipped with power management option to perform the following procedure.

Select Diagnostics (Item 1) from the main screen.

Select System Diagnostics (Item 1) from the diagnose/calibrate screen.

Start the utility work machine.

Select Throttle Sensor (Item 1) from the diagnose/calibrate screen and follow the instructions on the service PC.

NOTE: There will be a

This Post: How to Calibrate Throttle Position Sensor for Bobcat 5600 Series ToolCat From ChinaOBD2 Official Blog
Please keep this link if you copy the post!