Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
This instruction show you guide on how to adjust neutral Kubota L3901 tractor transmission.
Related Contents:
2022 Kubota Takeuchi Diagmaster v22.08.01 v4.1.2 Software Free Download
Kubota EPC Spare Parts Catalogue 2021.06 Download
Kubota DST-I Diagnostic Tool
How to Adjust Neutral for Kubota L3901 Tractor Transmission
Adjusting Neutral
1 Disengage the front wheel drive lever. (Drive only rear wheels.)
2 Set the cruise control to “OFF” position. (HST pedal is neutral position.)
3 Check to see that the length (A) of HST neutral rod (5) is specified length.
If not, adjust as follows Length (A): 73.0 to 74.0 mm (2.88 to 2.91 in.).
4 Lift the rear of the tractor so that the rear wheels are off the ground and operate the engine at maximum speed and drive only rear wheels.
5 Slightly loosen the plate mounting screws (4).
6 Press the neutral holder arm (3) to the HST trunnion plate (1).
7 Then rotate the neutral holder (2) clockwise or counter clockwise until wheels stop completely.
8 Hold the neutral holder (2) and tighten the plate mounting screws (4).
NOTE
• Be sure to tighten the plate mounting screw with specified torque.
More repair case for Kubota,please refer to:Kubota Trouble Repair
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!