Location of the Cab Side
The fuse block and the relay panel are located inside the instrument panel as shown below.
[NOTE]
Be sure to use each capacity fuse designated in the above table.
Never use the capacity fuse exceeding the designated one in the above, otherwise over current may damage the harness wires and fusible linkage wires.
Related Contents:
Nexiq USB Link
2024.02 HINO Diagnostic Explorer DX3/DX2 Diagnostic Software Free Download
HINO Trucks EPC Electronic Parts Catalog 2018 2016 Free Download
Location of the Chassis Side
The fusible link block is installed in left side rail as shown below
[NOTE]
Do not remove the harness connector, fusible link block, and cover except for repair and/or inspection.
If removal is necessary, pay attention that water and/or foreign matter do not attach or enter
the connector, terminals, electric component box, and cover.
If repair or replacement is required, make sure there is no attachment or entry of water and/or
foreign matter. Mount properly to ensure waterproof function is not compromised.
DETAIL OF FUSIBLE LINK AND RELAY POSITION
- How to remove fusible link box cover.
1. Push lock lever and remove lock. (2 position, marked )
2. Pull-up 2 position of plate lock (marked ) and remove cover.
More case for HINO please refer to:HINO Trouble Repair
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!