Godiag ECU GPT Boot AD and SM2 Pro Read Hyundai M7.9.8/SIM2K ECU

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

Godiag ECU GPT Boot Adapter is able to work with SM2 Pro and PCMFLash software to identify and read Hyundai M7.9.8/SIM2K ECUs no issues.

What is Godiag ECU GPT Boot AD?

GODIAG ECU GPT Boot AD Programming Adapter can help customers read and write ECU data via OBD2 Bench, GPT Bench (no disassembling the ECU), and Boot method (disassembling the ECU). It is equipped with a short-circuit-proof BOOT resistance board connection line to protect the ECU. Customers can use it with J2534 devices and PCMFLash software.

Features:

ECU dedicated connection terminal.
Support manual ignition power control
The ECU interface cable is labeled
Support ECU conversion to OBD2 mode to read and write data
Support RESET, BOOT, CNF1, GPT1, GPT2, 5V, 3.3V, VPP, GND.
Support PCMFlash automatic control of ignition power supply
Support ECU opening BOOT method to read and write data
CANbus is equipped with a switch to freely select the 120Ω resistor
Support GPT to read and write data without disassembling the ECU.
Equipped with BOOT resistance board connecting cable [anti-lost resistor design]

Functions:

Godiag ECU GPT Boot AD can perform diagnostic functions with standard OBD2 protocol equipment, and support ECU reading and writing with J2534 devices.

Only Scanmatik 2 PRO for PCMflash allows you to form GPT1, GPT2 signals necessary to work with Module 71.

Other devices Scanmatik OpenPort 2.0, Mongoose JLR, MongoosePro JLR,

Teradyne GNA600 (VCM 1), Mazda VCM 2 supports OBD2 or BOOT 53 mode to read and write ECU data.