This training guide show a guide on how to use G-scan2 to perform Electrical Park Brake system sensor learning after G sensor replacement.
Procedures:
Connect G-scan2 diagnostic tool to vehicle,then enter main menu to select “DIAGNOSIS”
Select “Honda”
And here are two method to identify your vehicle models information:
1.Automatic selection
2.Manual selection
For “”Automatic selection”,click the button to wait
For “Manual selection”,select [International]–>[16PIN CONNECTOR]–>[Electric Parking Brake]
Select [Electric Parking Brake]
Select “Special Function”
Select “Sensor Calibration”
Memorizes the current output values of each sensors as [Learning Value] into Electric Parking Brake Unit
[Important]
This menu must be performed on the flat floor.
This feature is used when the G sensor is replaced.
Check that the following conditions are fulfilled.
Stop the vehicle at the flat floor
There are no DTCs on this system (except for C0062-54)
Click “OK” to continue
Make sure that there are no DTCs on this system
Turn the ignition switch off and then turn the ignition switch on
Wait..It will prompt you that the sensor calibration operation has been successful.
Done!
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!