This article show a guide on how to use FORScan to enable auto fold for Ford F150,hope it helps!
What You Need?
OHP Ford ELMconfig USB
FORScan Android/iOS/Window Free Download
How to Install & Configure FORScan for OHP ELMconfig
Procedures:
Connect your OHP Ford ELMconfig USB adapter to vehicle,then run FORScan on you laptop
Click “Connect to vehicle”
The FORScan will prompt you with the feedback needed massage,click “Yes” to continue
Then it will check your Ford F150 modules status as below
After then click the “Configuration and Programming” icon at left menu
Select “DDM”,then click “Run service procedure”
Prompt you with massage,just click “OK” to continue,
Then change the blocks values:
740-03-01:”A000 EB” to “A800 EB ”
740-12-01:”005A” to “F05A”
Click “Write All”
Click “Yes” to continue
Then stop service procedure,and back to the modules,then select “PDM” and click “Run service procedure”
Change the block 741-03-01 value “A000 EC” to “A800 EC”,block 741-12-01 value “005B” to “F05B”,click “Write All”
Block(s) programmed successfully,please cycle the ignition OFF and back ON
Done!
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!