The following is a typical adjustment procedure for an Eaton LRC type transmission slave control. It is recommended that the OEM Chassis Service Manual be consulted first.
Related Contents:
Eaton Service Ranger 4.8 2021 Diagnostic Software Installation Service
Procedure
1.Move the Gear Shift Lever forward or backward to the Neutral position.
2.Move the Gear Shift Lever sideways, toward Reverse,until you feel resistance from the Reverse Plunger Spring.
DO NOT shift to Reverse. The Shift Finger must remain in this position while you are making all the adjustments.
3.Remove the Cotter Pin, Castle Nut and Ball Joint A (see figure A) from the Selection Lever. Do not remove the Ball Joint from the Pivot Link.
4.Loosen the Cap Screw B (see figure A) and remove the Shift Arm from the inner Shift Shaft. Do not disconnect the Selection Lever from the Shift Arm.
5.Turn the Shift Arm until it is at a right angle (90
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!