Here is an illustration show you guide on how to remove and install intake throttle valve for Doosan machine with ISUZU 6UZI INT-Tier 4 engine.
Related Contents:
ISUZU E-IDSS 2022 2019 Engine Diagnostic Service System Free Download
ISUZU IDSS Diagnostic Tool
Procedures:
Intake Throttle Valve Removal
1.Battery Ground Cable Disconnect
Disengage the battery ground cable from the battery.
Caution: Do not disconnect the battery cable for 1 minute after turning OFF the ignition switch.
2.Engine Harness Disconnect
Disengage the harness connector from the intake throttle valve.
Note: Pull the lock operation portion to release the lock.
3.Intake Throttle Valve Removal
Remove the intake duct from the intake throttle valve.
Remove the intake throttle valve from the inlet duct.
Remove the O-ring from the intake throttle valve.
Intake Throttle Valve Installation
1.Install the O-ring to the intake throttle valve.
Install the intake throttle valve to the inlet duct.
Install the intake duct to the intake throttle valve.
tightening torque： 22 N・m { 2.2 kgf・m / 16 lb・ft }
2.Engine Harness Connect
Connect the harness connector to the intake throttle valve.
Note: After connecting the harness connector, press in the lock operation portion to lock.
3.Battery Ground Cable Connect
Connect the battery ground cable to the battery.
More repair cases for ISUZU engine,please refer to:ISUZU Engine Trouble Repair
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!