DIY:How to Remove ECU for Toyota FT86

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

This article show a guide on how to remove ECU for Toyota FT86.It is very easy for you to perform the ECU removal,and it take you about 15 minutes to complete it operations.

For some ECU chip tuning or immo data reading,you need to read out ECU data file,so you need to open the ECU cover,here is a article about: EDC16/EDC17/MED17 ECU Opening Guide (Try this project at your own risk!!!).And if you want to know more about Toyota projects,please check here:Toyota Trouble Repair

What You Need?
10mm crescent wrench (ratcheting preferred)
Needle nose pliers

The hardest part about this job is knowing where the ECU is, as well as working in an inverted position. The first few steps can be bypassed, but they allow a little more access to the ECU and bolts.

The ECU is located on the passenger side of the vehicle, right above the kick panel, behind the dash.

First, to get more light in remove the end piece from the dash. You can take it off by pulling up and away from the bottom. It

This Post: DIY:How to Remove ECU for Toyota FT86 From ChinaOBD2 Official Blog
Please keep this link if you copy the post!

Tags: cat ECU chip tuning EDC17 immo