There is some latitude to relocate signals to different connector locations on the BC / ESC and the Remote Power Modules. This capability is limited to relocations that are configurable and are permitted by your DLB programming level.
Preparation:
Navistar Diamond Logic Builder (DLB) Free Download
How to Install Navistar Diamond Logic Builder (DLB) Software
DLB will generate an error message if you try to move something where is not permitted.
To move a signal:
1.Drag and drop the desired signal from its current location to a vacant location.
2.Save changes by doing one of the following:
- In the menu bar, select File > Save.
- In the toolbar, click the Save icon.
3.Program the changes into the vehicle.
Errors
If you do not have sufficient permissions to make the change, the following error will be displayed.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Related Posts
Renault CAN Clip V195 and Consult 3 III For Nissan Professional Diagnostic Tool ...
2020.11.4
Mercedes Benz E-class New Key Adding by Autel IM608 Pro 2
2023.04.20
How to Calculate PIN Code from BCM Dump for Opel Corsa-D
2023.04.4
How to Solve Xentry ConfigAssit
2023.04.4
How to Fix Error 749 for MB Star SD Connect C4 ?
2024.01.28
How to Identify Volkswagen Vehicle Immobilization Generations
2023.04.4
ODIS enables/disables VW/Audi component protection
2024.01.28
How to Remove Temperature Sensor for MTU 12-16v Engine
2024.08.10
Detroit DDEC6 Engine Password Protection Removal by Backdoor Calculator
2023.04.3
How to Access JLR SDD Engineering Mode (Seed Key)
2023.04.4