Connection Methods for Launch X431 Diagnostic Tools

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

Method 1: Connection for Launch X431 Pro5

Device: Launch X431 Pro5
Connection: Micro USB to tablet
Details: For older X431 Pro5 models using the Smartlink VCI, connect via a USB cable (Type A to Type B).
Note: An additional DoIP cable is required for this method.

Method 2: Connection for Launch X431 Pro3 LINK

Device: Launch X431 Pro3 LINK
Connection: Standard Link connection
Details: Uses the default connection setup provided with the device. Ensure all necessary cables are present.

Method 3: Connection for Launch PAD VIII V2 LINK

Device: Launch PAD VIII V2
Connection: Standard Link connection
Details: For models like the PAD VIII V2, no extra DoIP cable is required. The device supports built-in communication protocols.

Method 4: Connection for Launch X431 Pro3, ACE, and Pro3 APEX

Device: Launch X431 Pro3, ACE, Pro3 APEX
Connection: DBScar VII+ adapter cable
Details: This method applies to newer tablets equipped with the DBScar VII adapter.

Method 5: Connection for Launch X431 PAD III/PAD VIII V2

Device: Launch X431 PAD III, PAD VIII V2
Connection: Y-splitter cable to RJ45
Details: This method integrates the DoIP protocol using the PCS 4 system. No additional DoIP cable is required.

General Information:

DoIP (Diagnostics over Internet Protocol) uses Ethernet as the communication medium, offering high-speed vehicle diagnostics.
Supported by manufacturers like BMW, Jaguar, and Volvo.

This Post: Connection Methods for Launch X431 Diagnostic Tools From ChinaOBD2 Official Blog
Please keep this link if you copy the post!