Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
Here is the instruction show the guide on how to remove reverser drive for CLAAS Lexion 480 combine agricultural machine.
Related Content:
CLAAS CDS 7.5 Diagnostic Software 2021 2020 Free Download
CLAAS USB Interface Diagnostic Adapter Package
Claas WebTIC Offline Repair & Service 2024 2015 Free Download
Removing the reverser drive
Raise the feed rake conveyor and secure by engaging the cutterbar cylinder safety lock.
Loosen and remove the set collar from the bearing plate.
Loosen the M 10 x 20 hex. bolt so that the bearing plate may be removed.
Remove the hose end that goes off to the tank from the hydraulic cylinder and plug it with a plastic cap.
Loosen the M 8 x 180 hex. bolt.
Remove the spring clamp.
Remove the M 8 x 65, the M 12 x 25 and the M 12 x 45 hex. bolts with eccentric bolt from the hydraulic cylinder and remove the cylinder.
Remove the supporting arm with the hydraulic motor and the drive gear.
Unscrew the M 8 x 25 hex. bolt from the face end of the hydraulic motor.
Using a two-legged puller and a M 8 hex. bolt with centraliser, pull off the gear.
Loosen the M 12 x 35 hex. bolts and remove the hydraulic motor from the supporting arm.
More repair case for CLAAS,please refer to CLAAS Trouble Repair
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Some Friends don't know how to activate win7, when they receive the diagnostic software with win7 sytem. http://www.chinaobd2.com/upload/software/win7activation.zip download this Read more
Please ensure that you choose computer systems that meet our requirements for the installation. You will find adetailed listing in Read more
Frequent oil changes are perhaps the most important procedure you can do to maintain and prolong the life of your Read more
This article show a guide on how to use G-scan2
Please keep this link if you copy the post!