How to use CGDI Prog BMW to add new BMW FEM/BDC Keys with Godiag FEM/BDC Test Platform? Check the following operation guide.
1.Connection:
Connect CGDI BMW key programmer to computer via USB cable, and connect to Godiag BMW FEM/BDC Test Platform via OBD cable
Then connect Godiag Test Platform to FEM/BDC module
Finally, supply power to Godiag FEM Test Platform
2.Read original car key
Run CGDI BMW software
Click FEM/BDC Key Match on the main menu
Select one blank key (i.e. key 8) and click “Generate dealer key”
Select “Reading the car key” to enter the ISN code, and click “Next step”
Put the original key into to the induction coil of Godiag BMW FEM/BDC Programming Test Platform
Read the key info successfully.
3.Generate and identify new key with Autel KM100
Use Autel MaxiIM KM100E to generate the new key
After generation is successful, read the key info, the key status is not locked.
4.Program new key with CGDI BMW
Put the new key generated into to the induction coil of Godiag FEM Test Platform
Program key successfully
Press the Start button of Godiag Test Platform, the programmed key lights up the analog dashboard
5.Identify new key with Autel KM100
Use Autel KM100E to read the new key again, the key is locked now.
That means the key programming is successful.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!