Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
CG100 Prog III with software V6.5.4.0 (above) can repair 2015 onwards Mercedes-Benz 48V lithium battery W167/ W205/W213/W222 (click here to review). CGDI CG100X Programmer also has this ability for 2015-95M01 M256-straight and M264- elbow.
How to repair Mercedes-Benz 48V lithium battery by CG100X?
Main operation guide:
Step 1.Determine whether the cooling water pipe is a curved pipe or a straight pipe
Step 2.Remove the BMS for repair with CG100X programmer
Step 3.Charge the battery to the rated voltage (Please do not install BMS)
Step 4.After charging is completed, put back the BMS and DC/DC
In detail…
CG100X software menu function path:
BCM>> Benz>> 48V starter battery>> W167/ W205/W213/W222>> 2015-95M01 (M256-straight) or 2015-95M01 (M264- elbow)
Precautions:
1.Pay attention to the Pin 1 position of the Benz instrument module before removing the chip
After removing the IC chip (8 foot 95M01=5M1W3), please clean it to ensure contaction is successful
2.Pay attention to the Pin 1 position when operating the EEPROM Adapter
Solder IC chip to EE adapter and connect with CGDI CG100X
3.Read and save the original data, automatically identify the device, enter the target mileage, and modify the software automatically
4.The modification is completed. There is no need to click “Write”, weld back to the Benz instrument module and install back on the vehicle.
Just follow the above instruction to operate step by step.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!