CG FC200 ECU programme read and write 2010 BMW X1 E84 Bosch EDC17CP02.
Detail Steps:
Connect CG FC200 to ECU and computer correctly
Then run CG FC200 software (it’s V3.0)
Select BMW, X1 Series (E84), 20d sDrive N47D20 177, BOSCH EDC17CP02 TC1766
And click Platform to enter the operation interface
The wiring diagram is clear to see.
Identify the ECU successfully
Then start to read DFlash, PFlash and write PFlash one by one.
Read Dflash data and backup
Read Pflash data and backup
After backup, write Pflash
Select the original stage 1 file to write back
You don’t want to pay extra for that.
Confirm to verify the file to be written (verify the file is correct or not)
Write data successfully
There is a little bit different on this program is this file and another one existing in the ECU
Finally, install the ECU back to the car and test
It starts normally.
Learn more: https://www.chinaobd2.com/vp-cg-fc200-ecu-programmer.html
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!