Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
The Engine Control Module (ECM) detects one of the following conditions:
The “Allow Idle Shutdown Override” parameter is programmed to “Yes” and the status of the brake switch or the clutch switch changes.
The “Allow Idle Shutdown Override” parameter is programmed to “J1587 Outside Temp Based” or “Outside Temperature Based”. The outside temperature is above the maximum programmed temperature or the outside temperature is below the minimum programmed temperature.
Related Contents:
Caterpillar ET 2024A 2023A 2018A Diagnostic Software Free Download
CAT Communication Adapter 3 478-0235
Caterpillar Factory 18 Digits Password Service
The ECM also detects the following conditions:
The idle shutdown timer is within the final 90 seconds.
The “Idle Shutdown Time” parameter is programmed to at least three minutes.
The idle shutdown timer is intended to improve fuel economy by limiting idling time. The idle shutdown timer is a customer specified parameter that may be programmed for any period from 3 to 1440 minutes.
The timer is activated when all of the following conditions are met regardless of the position of the parking brake:
The vehicle speed is zero.
The engine is not in cold mode or dedicated PTO mode.
The engine is not under load.
The timer can be reset by moving the vehicle or the timer can be reset by quickly depressing the accelerator pedal and releasing the accelerator pedal. The check engine lamp will begin to rapidly flash 90 seconds before the programmed time expires. During this 90 second time period, the following conditions can disable the timer:
The clutch pedal is depressed.
The service brake pedal is depressed.
Possible Causes:
1) ECM not programmed properly
2) Clutch or Brake pedal/sensor failure
3) Wiring for clutch and/or brake sensor position failure
4) Vehicle speed sensor failure (Speedometer not reading correctly)
5) PTO Switch or harness failure
More repair case for Caterpillar machine,please refer to:Caterpillar Machine Repair
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Tags: Caterpillar
Related Posts
JPRO Professional 2025 V1 Update
2025.03.12
Caterpillar ET 2024C 2024A 2023A 2019C Electronic Technician Software Free Downl...
2025.03.12
Nexiq ETechnician V2.12 Diagnostic Software 2024.09
2025.03.12
Caterpillar C9 Engine Coolant Level Signal Invalid Fault Code 12 111-2
2025.01.23
Caterpillar C9 00 246-11 247-11 Brake Pedal Switch Fault Solution
2024.12.24
How to Solve Caterpillar C9 Engine Coolant Level Voltage High 12 111-3 Fault
2025.02.9
LAUNCH CRP129 HD Heavy Duty Diagnostic Tool Full System Truck Scanner
2025.03.12
Caterpillar C9 Engine Injection Actuation Pressure Output Fault Solution
2025.07.9
Caterpillar C9 Hassle Code 00 231-12 ECM J1939 Machine Not Responding
2024.12.9
What is GODIAG GT106 Plus? How to Use?
2024.12.24